MPC755 - ACT Technico MPC755 Extended Temperature 6U VME 5106 PowerPC Processor...
- Part Number:
- MPC755
- Model Number:
- MPC755
- Make:
- ACT/TECHNICO
- Lead Time:
- Available
- Qty In Stock:
- Available
ACT Technico MPC755 Extended Temperature 6U VME 5106 PowerPC Processor Blade with Two Intel 82559ER Ethernet Controllers and MPC775 Class Microprocessor Simple Type: Processor Blade
For Resellers and High Volume Orders:
Please request a quote to obtain preferred pricing.
Features
- 100 MHz front-side bus
- 17MB Flash memory
- 32KB NVRAM and time-of-day clock with replaceable battery backup
- 400MHz MPC755 class microprocessor with 32KB/32KB L1 cache
- 64-bit PCI expansion mezzanine connector allowing up to four more PMCs
- Commercial temperature versions available
- Dual 10BaseT/100BaseTX Ethernet
- Dual 16550 compatible async serial ports
- Dual IEEE P1386.1 compatible 32/64-bit PMC expansion slots
- Four 32-bit timers and one watchdog timer
- MVME5106 supports booting a variety of operating systems
- On-board debug monitor
- Operating temperature range -20°C to +71°C
- Optional Transition Module for rear panel I/O
- Single VME slot even when fully configured with two PMC modules and both add-on memory mezzanines
- Up to 2MB of secondary backside cache
- Up to 512MB of on-board ECC SDRAM-expandable up to 1GB with optional RAM500 memory expansion modules
Specifications
- Board Unique ID: Height: 233.4 mm (9.2 in.) Depth: 160.0 mm (6.3 in.) Front Panel Height: 261.8 mm (10.3 in.) Width: 19.8 mm (0.8 in.) Max. Component Height: 14.8 mm (0.58 in.)
- Compactflash: Capacity: Up to 512MB on-board, expandable to 1GB with RAM500 memory mezzanines Single Cycle Accesses: 10 Read/5 Write Read Burst Mode: 7-1-1-1 idle; 2-1-1-1 aligned page hit Write Burst Mode: 4-1-1-1 idle; 2-1-1-1 aligned page hit Architecture: 64-bit, single interleave
- EIDE: Counters/Timers TOD Clock Device: M48T37V Real-Time Timers/Counters:Four, 32-bit programmable Watchdog Timer: Time-out generates reset
- Ethernet: Controller: Two Intel 82559ER Interface Speed: 10/100Mb/s PCI Local bus DMA: Yes, with PCI burst Connector: One routed to front panel RJ-45, one routed to front panel RJ-45 or optionally routed to P2, RJ-45 on MVME761
- ISA: Controller: 16C550C UART Number of Ports: Two, 16550 compatible Configuration: EIA-574 DTE Async Baud Rate, bps max.: 38.4K EIA-232, 115Kbps raw Connector: One routed to front panel RJ-45, one on planar for development use
- L3 Cache: Intended for use in systems meeting the following regulations: U.S.: FCC Part 15, Subpart B, Class A (non-residential) Canada: ICES-003, Class A (non-residential) This product was tested in a representative system to the following standards: CE Mark per European EMC Directive 89/336/EEC with Amendments; Emissions: EN55022 Class B; Immunity: EN55024
- LVDS: Address/Data: A32/D32/D64, PMC PN1, PN2, PN3, PN4 connectors PCI Bus Clock: 33 MHz Signaling: 5V Power: +3.3V, +5V, ±12V; 7.5 watts maximum per PMC slot Module Types: Two single-wide or one double-wide, front panel or P2 I/O
- Mode: Firmware must fulfill the traditional functions of test and initialization and provide operating system boot support. TheMVME5106/7 firmware monitor exceeds these requirements with a proven monitor from the embedded VME leader. It expands features like power-up tests with extensive diagnostics, as well as a powerful evaluation and debug tool for simple checkout or when high-level development debuggers require additional support. All this is included with the MVME5100 firmware; plus it supports booting both operating systems and kernels.
- Power Requirement: (not including power required by PMC or IMPC modules): 3.0 A typ @ +5 V; +12 V @ 8.0 mA typ.; –12 V @ 2.0 mA typ.
- Processor: Microprocessor: MPC755 class Clock Frequency: 400 MHz (5106) or 500 MHz (5107) On-chip Cache (I/D): 32K/32K Secondary Cache: 1MB
- Processor Side Bus Frequency: Type: EEPROM, on-board programmable Capacity: 1MB via two 32-pin PLCC/CLCC sockets; 16MB surface mount Read Access (16MB port): 70 clocks (32-byte burst) Read Access (1MB port): 262 clocks (32-byte burst)
- SATA: All printed wiring boards (PWBs) are manufactured with a flammability rating of 94V-0 by UL recognized manufacturers.
- Socket: MVME5100 supports booting a variety of operating systems: Wind River Systems: VxWorks Green Hills: Integrity Multiple Partners: Linux
- Tv-out: Capacity: 32KB (4KB available for users) Cell Storage Life: 50 years at 55° C Cell Capacity Life: 5 years at 100% duty cycle, 25°C Removable Battery: Yes
- VGA: (based on a sample of eight boards in accelerated stress environment) Mean: 190,509 hours 95% Confidence: 107,681 hours
- Video Controller: Address/Data: A32/D32/D64 PCI Bus Clock: 33 MHz Signaling: 5V Connector: 114-pin connector located on the planar of the MVME5106/7
- Video Interface: Controller: Tundra Universe DTB Master: A16–A32; D08–D64, BLT DTB Slave: A24–A32; D08–D64, BLT, UAT Arbiter: RR/PRI Interrupt Handler/Generator: IRQ 1–7/Any one of seven IRQs System Controller: Yes, jumperable or auto detect Location Monitor: Two, LMA32
Applications
- None Available
Aliases
- None Available
Related Items
TVME5500-R
ACT/TECHNICO MVME5500 VMEbus Single Board Computer - MPC7455 @ 1GHz,
MVME5100-R
Act/Technico MVME5100-R VMEbus Processor Module - MPC7410 or MPC750 processor,
MPC7457
ACT Technico MPC7457 2eSST VMEbus MPC7457 PowerPC® single-board computer