ACT/TECHNICO Industrial Partner

CPCI-6065 - Emerson Network Power CPCI Board with PowerPlus II Architecture Simple...

larger image

Request Quote
For Price
Part Number:
CPCI-6065
Model Number:
CPCI-6065
Make:
ACT/TECHNICO
Lead Time:
Available
Qty In Stock:
Available

Emerson Network Power CPCI Board with PowerPlus II Architecture Simple Type: PowerPC

Download the datasheet (PDF)

For Resellers and High Volume Orders:
Please request a quote to obtain preferred pricing.

Features

  • 16MB on-board flash memory for user-specified requirements
  • 1MB or 2MB of L2 cache
  • 32KB NVRAM and time-of-day clock with replaceable battery backup
  • Dual 10/100BaseTX Ethernet interface
  • Four 32-bit timers, one watchdog timer
  • MPC7410 or MPC750 class processor
  • On-board debug monitor with self-test diagnostics
  • Optional Compact Flash memory card socket on accompanying transition module
  • Two 32-pin PLCC/CLCC sockets for flash memory, up to 1MB capacity for on-board firmware or user specified requirements
  • Two 32/64-bit PMC expansion slots with front-panel or backplane I/O
  • Two USB ports, four async serial ports
  • Up to 1.5GB ECC SDRAM, with optional RAM500 memory expansion modules

Specifications

    General
  • Board Unique ID: Height: 233.4 mm (9.2 in.) Depth: 160.0 mm (6.3 in.) Front Panel Height: 261.8 mm (10.3 in.) Width: 19.8 mm (0.8 in.) Max. Component Height: 14.8 mm (0.58 in.)
  • Compactflash: ECC Protected Main Memory: PC100 SDRAM with 100 MHz bus Capacity: 64MB to 1.5GB Single Cycle Accesses: 10 read/5 write Read Burst Mode: 7-1-1-1 idle; 2-1-1-1 aligned page hit Write Burst Mode: 4-1-1-1 idle; 2-1-1-1 aligned page hit L2 Cache: 1MB (750) or 2MB (7410) EEPROM/Flash: On-board programmable Capacity: 1MB via two 32-pin PLCC/CLCC sockets; 16MB surface mount Read Access (8MB port): 70 clocks (32-byte burst) Read Access (1MB port): 262 clocks (32-byte burst) NVRAM: 32KB; 24KB available for users Cell Capacity Life: 5 years at 100% duty cycle, 25° C Removable Battery: Yes
  • Compliance: Controller: Intel® 2155x Address/Data: A32/D32/D64 PCI Bus Clock: 33 MHz Signaling: 3.3V output; input defined by VIO
  • CPU: Microprocessor: 450 or 500 MHz MPC750 class or 500 MHz MPC7410 On-chip Cache (I/D): 32K/32K
  • EIDE: TOD Clock Device: M48T37V; 32KB NVRAM Real-Time Timers/Counters: Four 32-bit programmable Watchdog Timer: Time-out generates reset
  • Environment: Operating Non-operating Temperature: 0° C to +55° C, forced air cooling –40° C to +85° C Humidity (NC): 0% to 80%(operating) 10% to 90% (non-operating) Vibration: 0.5 G RMS, 20–2000 Hz (operating) 6.0 Gs RMS, 20–2000 Hz (non-operating)
  • Ethernet: Controller: Two Intel® 21143 Interface Speed: 10/100Mbps PCI Local bus DMA: Yes, with PCI burst Connector: One RJ-45 on front panel or J5/TM, one additional J5/TM only
  • ISA: Controller: 16C550C UART Number of Ports: Four Async Baud Rate, bps max.: 38.4K EIA-232 Connector (COM1): Front panel; also RJ-45 on CPCI-6065-TM-PIMC101 Connector (COM2/3/4): Routed to J3; one RJ-45, two headers on CPCI-6065-TM-PIMC101
  • L3 Cache: Intended for use in systems meeting the following regulations: U.S.: FCC Part 15, Subpart B, Class A (non-residential) Canada: ICES-003, Class A (non-residential)
  • LVDS: Address/Data: A32/D32/D64, PMC JN1, JN2, JN3, JN4 connectors PCI Bus Clock: 33 MHz Signaling: 5V Power: +3.3V, +5V, ±12V, 7.5 watts maximum per PMC slot Module Types: Two single-wide or one double-wide, front panel I/O or J3 and J5 I/O; supports PrPMC module type PMCs (maximum, not including PMC modules) Note: Due to high component density, uninsulated traces and vias are located in the CPCI-6065 I/O keepoutarea. If installed, PMC modules having conductive I/O connectors could contact these traces and vias. If full IEEE 1386-2001 compliance is required, an insulating shield (e.g., Kapton tape) should be installed.
  • Power Requirement: (maximum, not including PMC modules) +3.3V ±5% +5V ±5% +12V ±5% –12V ±5% CPCI-6065- 3371 2.97 A 2.65 A 20 mA <10 mA CPCI-6065- 8371 2.97 A 3.65 A 20 mA <10 mA
  • RTC: (based on a sample of eight boards in accelerated stress environment) Mean: 214,322 hours 95% Confidence: 121,141 hours
  • SATA: All printed wiring boards (PWBs) are manufactured with a flammability rating of 94V-0 by UL recognized manufacturers.
  • SATA: Reset/Abort switch (recessed on the MPC7410) on front panel Three LEDs for FAIL, CPU activity and hot swap
  • USB: Controller: 82C586 or 82C686 Connectors: Routed to J3 for use of two Series A receptacles on optional host interface module

 

Applications

  • None Available

Aliases

  • None Available