PP421 - 6U cPCI Dual-Core Intel® Xeon® 1.66MHz ULV processor Single Board...
- Part Number:
- PP421
- Model Number:
- PP421
- Make:
- ACT/TECHNICO
- Lead Time:
- Available
- Qty In Stock:
- Available
6U cPCI Dual-Core Intel® Xeon® 1.66MHz ULV processor Single Board Computer Simple Type: Pentium
For Resellers and High Volume Orders:
Please request a quote to obtain preferred pricing.
Features
- 0°C to +55°C (operating)
- 1 EIDE, 2 SATA Interfaces
- 1 Mbyte of BIOS Flash EPROM
- 1 x PMC site
- 1 x USB 2.0 interface via front panel
- 2 Mbytes secondary (L2) shared on-die cache
- 2 x asynchronous RS232 serial channels
- 3 x USB 2.0 interfaces accessed via J5 to the Transition Module
- 4 Gigabit Ethernet ports
- High resolution graphics interface
- Intel® CoreT Microarchitecture
- Internal primary (L1) on-die cache
- Supports 667 MHz processor bus to give peak bandwidth of 5.3 Gbytes/s
- Supports up to 8 Gbytes DDR2-400 ECC SDRAM
Specifications
- Compliance: compliant with PICMG 2.0 R3.0; 3.3V and 5V signaling levels: universal signaling supported 33/66 MHz; 32/64-bit interface accessed via J1/J2 connectors utilizing a PCI-X to PCI Bridge for off-board accesses PICMG 2.1 R2.0 Hot Swap Specification compatible as hot swap controller only J4 connector not fitted operates as a system slot controller or in a peripheral slot option to disable CompactPCI interface(Satellite Mode): use in any slot recieves power from CompactPCI bus board can be hot swapped in this mode
- CPU: Dual Processors for each processor: 1.66 GHz Dual-core Intel Xeon processor ULV Internal primary (L1) on-die cache 2 Mbytes secondary (L2) shared on-die cache Intel Core Microarchitecture No CPU fan required Utilizes 64-bit Intel E7520 chipset: Supports 667 MHz processor bus to give peak bandwidth of 5.3 Gbytes/s Uses Intel 6300ESB I/O Controller Hub
- Dimensions: Supports up to 8 Gbytes DDR2-400 ECC SDRAM: up to 4 Gbytes soldered to board up to 4 Gbytes provided via two 200-pin SODIMM sockets dual channel configuration peak bandwidth of 6.4 Gbytes/s error correction up to 4 bits Accessible from processors and CompactPCI bus
- Environment: 0C to +55C (operating) 10% to 90% Relative Humidity (operating non-condensing) -40C to +85C (storage) 10% to 90% Relative Humidity (storage non-condensing)
- Ethernet: 4x channels supporting 10Base-T, 100 Base-TX, 1000 Base-T front panel interfaces: implemented by an Intel 82571EB LAN controller via a x4 PCI Express link accessed via front panel RJ45 Connectors Rear I/O Interfaces: implemented by a 2x Intel 82573L LAN controllers via x1 PCI Express links support for PICMG 2.16 Packet Switching Backplane (PSB) Optional support for rear panel RJ45's via J3 to the Transition Module
- Expansion Interface: +5V@4.0A (Typical with 2Gbtes DRAM); +5%/-3% +3.3V@7.0A; +5%/-3% +12V@0.02A; -12V@0.01A +12V and -12V routed to PMC expansion slot
- FDD: Phoenix TrustedCore comprehensive Power-On Self Test(POST) Lan boot firmware included
- Form Factor: 1 Mbyte of BIOS Flash EPROM 8-bits wide
- Gross Weight: implemented by a Silicon Motion SM722: 8 Mbytes video memory resolution up to 1280x1024 @16M colors analog interface via front panel connector DVI-D interface supported via J3
- IDE Interface: EIDE Interface: Supports up to Ulta-DMA 100 for high performance drives 2x channel (primary and secondary) secondary channel can be used for on-board 2.5 inch disk drive or up to 2 Compactflash or Microdrive type II drives On-board options occupy the PMC site Primary channel accessed via J3 to the Transition Module Serial ATA Interfaces: 2x channels accessible via J5 transfer speeds up to 150 Mbytes/s
- Input: PICMG 2.9 R1.0 (System Management Specification) implements the IPMB0 and IPMB1 interfaces on-board Baseboard Management Controller supports 32 Kbytes of non-volatile memory
- Memory: 6U form factor: 9.2 inches x 6.3 inches (233mm x 160mm) single-slot: 0.8 inches (20.3 mm) connectors: IEC-1076-4-101 for J1-J5 shock: 20g, 11ms,1/2 sine (operating) 30g, 11ms, 1/2 sine (non-operating) vibration: 5Hz-2000Hz at 2g, 0.38mm peak displacement (operating); 5Hz-2000Hz at 5g, 0.76mm peak displacement (non-operating)
- OS: keyboard and mouse interfaces, sharing a single PS/2 type connector on front panel and accessible via J3 to the Transition Module PC-compatible Real Time Clock (Year-2000 compliant) 3x USB 2.0 interfaces accessed via J5 to the Transition Module 1x USB 2.0 interface via front panel watchdog timer system fan monitor; two CPU temperature monitors; voltages monitor; board temperature monitor: all accessible via IPMI legacy speaker interface
- Power Connector: 1xPMC site: 3.3V signaling supports 32/64 bit, 33/66 MHz PCI and 66 MHz PCI-X operation XMC (PCI Express Mezzannine Card) interface supported via x8 or dual x4 PCI Express Link I/O via front panel and via J5: Transition Module supports rear I/O
- SATA: PCM (PWB) manufactured with flammability rating of 94V-0
- Serial: 2x RS232 serial channels: one channel accessed via J3 to the Transition Module and front panel one channel accessed via J5 to the Transition Module 16550 compatible UART supports CTS, RTS, RI, DSR, DTR, and DCD
- Socket: support for Linux, Windows Server 2003, Windows XP, Windows 2000 and QNX
Applications
- None Available
Aliases
- None Available
